Side Panel Skids DIY

Technical info not specific to a particular mfr.
Respond to existing topics with questions or comments.
Post Reply
User avatar
4Strokes
Site Admin
Posts: 1211
Joined: May 02, 2016

Side Panel Skids DIY

Post by 4Strokes » Fri Jun 17, 2016 5:53 pm

side_skidsa.jpg
side_skidsb.jpg
These Side Panel Skids can be applied to any model dirt bike. Basically they are Teflon rod cut in half lengthwise then attached to the side panels with counter-sunk bolts. I used Teflon but any high density hard plastic would work. (Delrin is another material that would work well.) It takes about 1-2 hours to fabricate and install. Oh, and they have been field tested and held up just fine, no more scratched side panels!

Credits: Mod submitted by motomonte and edited by 4Strokes.com.

Post Reply

SPONSOR